the key technical indexes

1. Product model: WGL-60-93

2. Oxygen production of 60L / MIN

3. Compressed air consumption is 0.66 Nm3/ Min pressure:> 0.22MPa

4. Oxygen purity is 93%

5. Oxygen outlet pressure is 0.4Mpa

6. Oxygen generator power supply 220V / 50 hz power 4200W

7. Oxygen generator size is 120x50x150cm

8. Equipment weight: about 185 KG

1. application area

PSA oxygen generator is favored by the majority of users because of its remarkable advantages, it is widely used in metallurgical combustion, chemical industry, environmental protection, building materials, light industry, medical treatment, aquaculture, biotechnology, sewage treatment and other fields.

2. technical feature

Perfect fluency design, the optimal use of the effect;

Reasonable internal components, uniform airflow distribution, reduce the high-speed impact of the airflow;

Unique molecular sieve protection measures, prolong the service life of molecular sieve;

Simple operation, stable operation, high degree of automation, can be real unmanned operation;

Automatic interlocking oxygen exhaust device to ensure the oxygen quality of products;

3. operational principle

Using the principle of PSA pressure change adsorption, the air is pressurized and pressurized, and the nitrogen molecules and oxygen molecules in the air are separated through molecular screening, oxygen retention and nitrogen discharge. Through the power supply at room temperature, it can be continuously separated from the air to produce high concentration of oxygen under rated oxygen flow conditions.

4. Molecular sieve material

Using lithium low silicon oxygen molecular sieve (oxygen purity 93% ± 2), has the advantages of high oxygen purity, high yield ratio, small mechanical wear, long life and so on.

5. life length

 Oxygen purity decayed to 85% ± 3 after 6000 hours and 80% ± 3 after 10000 hours, used to

After 18,000 hours, the oxygen purity decreases to 70% + 3, and the internal molecular sieve needs to be replaced when the oxygen concentration is insufficient for use.

6. Environmental requirements for the use of the oxygen production system

1. Ambient temperature: 5℃ ~40℃

2, relative humidity: 80%

3. Atmospheric pressure: 86 kPa ~ 106 kPa

4, the surrounding environment without corrosive gas and strong magnetic field

 Vii. Operation method

1. Place the equipment in a specific position in the process (smooth, dry, good ventilation and heat dissipation), more than 40 cm from the wall; ensure that the silicone tube is connected to the oxygen outlet of the machine to facilitate oxygen delivery.

2. The oxygen generator must be higher than the water level to prevent the water from returning to the oxygen generator. Once the oxygen generator unit is flooded, the machine will not be used.

3. Turn on the power supply, the power supply indicator light is on, and the voltmeter shows the current voltage. Turn on the switch, the operation indicator light is on, the air pump starts working, the machine panel "flow meter" is adjusted to the required scale position, and the output port has oxygen output. After use, you need to turn off the switch.

VIII. Matters needing attention

Do not use this product near high-precision electronic equipment. Radio wave interference may cause misoperation and other problems of high-precision electronic equipment. Special attention should be paid near the following devices: hearing aids, pacemakers and other medical electronic devices, fire detectors, and other precision automatic control devices.

Do not remove or modify this product, otherwise it will cause damage, leakage and circuit failure.

Avoid excessive moisture, water or other liquid into the product may cause leakage and failure of the product.

Avoid wiping the equipment with a volatile solution or organic solvent and may damage the surface of the equipment.

Qualified special grounding wire, safe and reliable grounding, the capacity of the line is in line with the requirements, to ensure the elimination of fire hazards. Equipment installation personnel must be trained to start up for maintenance.

Remember that the equipment maintenance or repair must be carried out in the state of power failure and air pressure discharge, to ensure the safety of personnel maintenance.